20mm Hold for Hangboard and Climbing
100
views
6
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments... 
20mm Hold for Hangboard and Climbing
3D
Published 2024-02-21T15:41:09+00:00
0
0
Add to Collection
Description
A 20mm edge/hold for mounting to a DIY home hangboard. One edge is flat, with the opposite having a slight concave for easier grip. Front contains a 6mm edge for those that are brave enough.
The edge is mounted to the board using 25mm M8 bolts, a 20mm washer which attaches into a M8 T-Nut on the other side of the board. If you would like an alternate attachemnt method, message me.
Licence
Détail de l'impression
Printed using 4 wall lines at 0.28mm layer height and a Infil of 30%. This seems strong enough.
These were printed using the Fuzzy Skin setting on Cura to give more grip, but sanding the surfacing with rought sandpaper will also increase grip.
Technical Information
| Date de publication | 21/02/2024 |
| Sans support | YES |
More Information
Object Parts
