Citadel Paint Spill Protector - Paint Pot Holder
Citadel Paint Spill Protector - Paint Pot Holder
3D
Published 2022-01-29T01:25:21+00:00
Makes it less likely to accidentally tip over your favourite shade or contrast paint.
Squeeze on design to fit most of the citadel paint range.
As a bonus you can fit a 32mm base in the middle and make a cool objective marker.
Print flat on plate if you have a magnetic flexiplate it's easy to remove, if not you might need to support it vertically.
Check out my cults page: https://cults3d.com/en/users/Rodross27/creations
Chitchubox settings: (Anycubic Mono SE)
Layer Height:0.05
Bottom Layer Count: 4
Exposure Time: 1.5
Bottom Exposure Time: 30
Light-off Delay:1
Bottom Light-off Delay: 1
Bottom Lift Distance: 8
Lifting Distance: 8
Bottom Lift Speed: 120 mm/min
Lifting Speed: 180 mm/min
Retract Speed: 180 mm/min
Resin: Anycubic Plant Based
About 40 mins.
| Date de publication | 29/01/2022 |
| Durée d’impression | 40 - minutes |
| Sans support | YES |
