"demibot" skids (bottommount)
420
views
16
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments... 
"demibot" skids (bottommount)
3D
Published 2022-12-21T11:08:36+00:00
0
0
Add to Collection
Description
These are the bottom mount version of the skids from the "demibot" frame skins bundle. The bulk of the tpu is at the front and rear where most impacts happen. The engineering behind these skids and the bottom mount ones is that the tpu goes inbetween the horns on the arm ends which spreads the impact over more surface than if only the leading edge was protected. This keeps the horns from taking the hit and delaminating. These are made to be hardcore but minimal.
consider donating a couple dollars so I can keep bringing you parts
Licence
Détail de l'impression
No supports, hotend temp 200 degrees on first layer/ 190 degrees after that. Fan 90%, 100% on bridging. Speed 45mm, 25mm on bridging.
Technical Information
| Date de publication | 21/12/2022 |
| Durée d’impression | 18 - minutes |
| Quantité de filament | 4 |
| Sans support | YES |
More Information
Object Parts
