Destiny 2 Submission SMG
Destiny 2 Submission SMG
3D
Published 2023-07-12T08:20:06+00:00
This is a model of one of my favourite PVE SMG's from Destiny 2's Vow of the Disciple raid - Submission. I decided to paint it with the Jacarina shader.
Details:
It took just over a week to print on my Ender 3 v2, using a bit under 1kg of PLA filament with some sub-optimal supports. It is assembled using 3mm pins and press-fits, with super glue only needed for the sight and joining the trigger guards together.
It is ~60cm in length, and 6cm wide at its widest points along the barrel.
Features:
Two 8mm diameter and 3mm deep holes are present at the top of the magazine and within the grip, where rare earth magnets of the same size can be press-fit inside. This allows the magazine to slide in - stay in - and out of the bottom of the grip, like in-game.
There is a compartment in the lower body of the model, where a rubber band can be used to create a mechanism that allows the trigger to be pulled back and return to its resting position. A similar compartment is located in the upper body, where the loading slider can be pulled back like in-game too, using a rubber band.
Very happy with how it turned out, and am keen for any suggestions to make further props, whether it be from Destiny, Overwatch, or other games.
Hope you guys enjoy it too!
| Date de publication | 12/07/2023 |
| Dimensions | 600mm x 60mm x 250mm |