--- FaceShield V1.3 Comfort --- (23min print time Vase mode with 1mm nozzle)
--- FaceShield V1.3 Comfort --- (23min print time Vase mode with 1mm nozzle)
3D
Published 2020-03-27T01:10:19+00:00
Ready to use after printing.
Version 1.3 Comfort, that is more comfortable than Version 1.2.
UPDATE:
STOCKS! + INSTRUCTION (Polish)
5 - 10 - 15 pcs at once.
JUST ADD SUPPORT ON HANGS AT FRONT!
0,3 Gap is for 0.4 nozzle and 0,25 layer height.
0,5 gap is for 1.0 nozzle and 5.5 layer height.
---> VERSION 1.2 is here https://www.myminifactory.com/object/3d-print-115134 but recommended print 1.3 Comfort :)
USE PET or PET-G ONLY
PLA IS NOT RECOMMENDED.
-1mm nozzle - extrusion set to 0.95 (same for Nozzle 0.4, should be fine)
Tips for 1mm nozzle - set temp 240-250C, or change it when printing, if you hear "cracks" from nozzle and see pause in prints - its too hot, set 5C less and try again.
-0.5-0.6mm Layer Height (depend of your printer and settings) (nozzle 0.4 set max 0.3LH)
-Vase mode (without TOP and BOTTOM) to print super clear without strings
-WITHOUT ANY SUPPORT <3
Should take 31 gram of PET-G and 25 min.
Version Comfort 28,53 gram and 23 min. :)
On my printer i can stock 8 of them at once, but recommended is printing one by one in vase mode
Version comfort cant be stocked one on one like version 1.2
TIPS from this file go for more filament, bindings covers and rubber ropes, you can help me with it.
| Date de publication | 27/03/2020 |
| Durée d’impression | - 25 minutes |
| Quantité de filament | 28,5 gram |
| Dimensions | 166,47 x 141,22 x 20 |
| Sans support | YES |
V1.3 ; Anet A8 ; PET PlastSpaw ; temp 235/75 ; nozzle 0.4; layer width 0.5 ; layer height 0.302 ; time 1h25min ; zero cooling ; more comfortable than 1.2 ver