Gengar with base pokemon 3d print
Gengar with base pokemon 3d print
3D
Published 2021-11-15T08:44:34+00:00
3d Gengar model. Comes with a base and a hole in the base in which the tail fits. Comes in two pieces. Based on the model by @amilcaretonnarelli
https://www.myminifactory.com/object/3d-print-gengar-158531#
I wanted a gengar that looked kind of crazy and like a psychopath. Unfortunately I didn't find many gengars in the web. So I took a very good model and modified it a little bit in zbrush. The eyes were sculpted to give the desired look and feel. The teeth were also modified a littlebit and the hands were given some slightly harder edges to make them look like they were more anatomical. Frowning and smile cheek holes were also added.
The tail has a cylinder that works as a support. The base has a hole that fits this support. Depending on the settings of the print, the base may be enlarged a few % to take into account dimensional inaccuracies of the resin/filament and better fit the tail without having to sand.
The model was printed and tested on an EPAX X1K using EPAX hard white at 0.05mm layer heights and primed with rustoleum grey primer. The model is about 7 cm tall.
Hope you all like it!
JuanDa
Instagram and Facebook:
@wic3d
| Date de publication | 15/11/2021 |