Mask Drying Hook for Mounting on 1/2-Inch Pipe to Dry Washable Face Masks
Mask Drying Hook for Mounting on 1/2-Inch Pipe to Dry Washable Face Masks
3D
Published 2020-10-19T15:45:14+00:00
Hang your washable face masks to dry from half-inch cold water pipe (or mount a half-inch PVC pipe) with my mask hooks.
Original: Print, and then use your side cutters to snip the ring as seen in my picture. Twist sideways to affix to the cold water pipe. These must be snipped as shown, and will hold nice and snug to any half-inch pipe.
v2: Revised version features a hook on both sides of each stem. Also comes pre-cut, so no need to cut with your side cutters.
v2.2: Updated to my wife's specifications: Now, the stem is slightly longer (making it easier for her to reach).
This is my first time trying 3D Printing, and I'm super proud that I was able to make something (albeit basic) that serves a legit purpose. I hope you like it.
Infill: 30%
Infill Pattern: Triangle
Layer Height: 0.2mm
| Date de publication | 19/10/2020 |
| Sans support | YES |