Pixel 5 Bumper Case
Pixel 5 Bumper Case
3D
Published 2021-04-12T11:56:53+00:00
Could'nt find a Pixel 5 Case to either purchase or print, so I designed it myself and printed it in TPU.
The Case is rather hard to get on but fits great afterwards which was worth the struggle, for me at least. without a skin it's a little easier but you should keep attention to the sides ripping while bending the last corner around the device.
If you have any tips for improvement or similar I'd love to hear them in the comments.
I have included the model of the phone I made too if someone wants to make accessoires for himself.
Printer: Creality Ender 3
Supports: Yes
Resolution: 0.12mm
Filament: TPU
Notes:
I had to print with a rather large brim (8lines) to prevent warping on the corners.
A low support density makes it significantly easier to remove them afterwards too (mine was 10%). I printed the case laying flat with the top facing upwards.
| Date de publication | 12/04/2021 |
| Durée d’impression | 180 - 360 minutes |
| Quantité de filament | 15g |
| Dimensions | 75x150x10mm |