Print-In-Place Caliper Case
$5.00 Print-In-Place Caliper Case
Published 2022-08-01T10:20:45+00:00
Certainly not the first caliper case out there, but allow me to throw my hat in the ring with a design that I feel fills in most of the needs of the other designs, with all due respect to their creators!
The Cylinder in the front is turn lock with the fingers on the side locking it into place, the little tower in front is just a custom support meant to be broken off after print.
The mirrored clips near the hinges are meant ot hold spare batteries.
0.20 mm layer height
3-4 walls
20-40% infill
Support: Buildplate Only (0.2 gap) Also that little vertical tower in front is a support that shoudl be broken off after print.
Filament must be dry as stringing will cause the lock in the front to seize.
As for getting those patters in the picture?
PrusaSlicer:
Print Settings > Infill > Top Infill Pattern (and Bottom Infill Pattern)
Date de publication | 01/08/2022 |
Price | $5.00 |
Quantité de filament | 190.20g |
Dimensions | 245.00mm x 209.04mm x 22.83mm |
Technologie | FDM |