Swivel Nozzle for Jet Engine, 3 Bearing Type, [Phase 1], Option
$10.00 Swivel Nozzle for Jet Engine, 3 Bearing Type, [Phase 1], Option
Published 2021-07-01T09:04:35+00:00
I am interesting about the Swivel Nozzle called 3 Bearing Swivel Nozzle (3BSN) for Jet Engine for the recent STOL Fighter.
So I made the following model series before;
[Basic Model]
- Phase 1 - Basic Model - Each BRG can be turned individually by Knob
[Manual Model] - Phase 1 + ;
- Phase 2 - #2 & 3 BRGs are geared to synchronize and can be turned by 2 Hands.
- Phase 3 - All BRGs are connected with Gearbox and can be turned by Single Knob.
- Phase 4 - Phase 3 + Additional GB. This is my Target Model to turn Single Lever.
[Motor Driven Model] - Phase 1 + ;
- Motor Driven Synchro-GB, Pars
This model is designed to improve duct bearings using “Ball” in order to get more stable movement and is fully interchangeable of [Basic Model].
https://www.myminifactory.com/object/3d-print-swivel-nozzle-for-jet-engine-3-bearing-type-phase-1-84213
A. Design points:
1. This model is completely interchangeable to [Manual] and [Motor Driven] model because of using same gear requirement.
2. Duct inside diameter reduced from 70 mm to 62mm.
B Assembly Manual (PDF format, total 12 pages)
The detail assembly manual including "Parts-List", "After printing treatment" and "Assembly procedure" are prepared based on "Standard Skill (Filing, Drilling, Tapping and painting)".
C. Download files includes;
- files: STL Files (16 items)
- “ws” of last 2 digits means “With Support” special designed.
- PDF(Zip) File: Assembly Manual
D. Purchase Parts Information; - See Assembly Manual
- Steel Ball - φ3 (Approx. 100ea)
- Aluminum Tubes - φ9
- Screws
Micro screws M1.4x6L - Direct screw-in to 1 mm dia hole (No nut)
But there are many small parts, if you can get M1.4-P0.3 Tap, using it to make introducing thread is recommended.
Quantity of screws can be adjusted by your experience.
E. Total Net Print Time: Approx. 40 HR
- (Estimated as case of PLA, 0.4mm Nozzle, 0.2mm Layer Height, 40% infill and No raft and support)
Note: When at actual print, each parameter may be adjusted by your experience.
For parts having gear teeth, 100% infill and 0.2mm Layer Height are recommended.
See Manual.
Date de publication | 01/07/2021 |
Price | $10.00 |