Test block B
144
views
0
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments...
Test block B
3D
Published 2023-09-25T10:15:18+00:00
0
0
Add to Collection
Description
Test Block 2
A simple geometric test block i use to test Extrusion/Heat/Overhang Ratio along side ironing.
Also give's a good idea of resolution over curve's and angle's.
Approx 30mm x 30mm x 20mm.
If calibrated properly will give nice clean sharp edges and smooth to surface.
If calibrated poorly..
Droop's on lower side sphere = Too hot or Over Extrusion
Loss of definition at top of triangle = Too cold/ Under Extrusion
Uneven/patchy top surface = Under Extrusion Probably...
Lump on Far side square corner = Over Extrusion
This object was made in Tinkercad. https://www.tinkercad.com/things/gAvrg1f8vvp
Licence
Détail de l'impression
Print single shell to test Clarity alongside everything else.
Technical Information
Date de publication | 25/09/2023 |
Dimensions | 30x30x20 |
Technologie | FDM |
Sans support | YES |
More Information
Object Parts