TS100 Case
TS100 Case
3D
Published 2021-12-14T10:38:14+00:00
TS100 Case
I needed a case for my TS100 and 5 additional tips. Since there were no file out there, that satisfied my needs, i designed my own.
Inspired by the toolcases of iFixit, I wanted mine to be made out of two parts hold together by magnets.
In the top part I also designed little compartments, to store screws or other small stuff when repairing something.
The tips and soldering iron are also held in place by magnets.
On the bottom of the main part are also magnets, to have the option on future expasions of this toolcase (for example a small powersupply, or just storage for soldering wire).
The magnets I used are 6mm diameter 2mm high round neodymium magnets
The photos are of version 1, where the clearance is just a bit to tight. I have adjusted those in the file, but I have not tested it.
Fully printable without supports.
License: CC BY-NC-SA 4.0
| Date de publication | 14/12/2021 |
| Sans support | YES |