V-Moda replacement wing plate - Wide
V-Moda replacement wing plate - Wide
3D
Published 2021-03-17T11:31:59+00:00
This are the L, R top and bottom covers for almost all of the V-Moda series (M-100, Crossfade LP , LP2, Wireless, Wireless 2) .
The originals tend to break because they have too much pressure, a bad angle and thin plastic.
Note: This is the "Wide version",i made this modfication specially for a diy replaced headband pad that is wider than the stock. This are wider than the original so they will not fit only 1 part, you need to use them in Top Bottom pairs.
If you want a more compatible version, check my other upload with a similar name.
For FDM print horizontally as shown in the photo for maximun strenght, otherwise you will suffer from breakage as the interlayer adhesion could be poor.
Calibrate well your machine, the screw pillars are within 0.2-0.4mm tolerances, otherwise they will not fit. if one of the pillars doesn't fit, just sand lightly.
| Date de publication | 17/03/2021 |