slingshotdesign's Print of 3DPIAwards Spiral Egg
Community Print Impression 3D de 3DPIAwards Spiral Egg
Published 2023-08-02T16:31:31+00:00
0
0
Printed on: Anycubic
Material: PLA
Description
Printed using opaque filament, because it's what I had on hand. I used Amolen 2-tone filament from Amazon, which turned out really fun in this print! I am still figuring out the perfect settings for my printer (I'm quite new to all this), and I believe I technically used a too-small line height, though it turned out just fine (I mistyped and didn't realize until much later).
Printer: Anycubic Kobra
PLA filament
temp for this filament w/ my printer was 207ºc, bed 60ºc
Accidental layer height: 0.18 (intended 0.28, but again it looks pretty good!)
speed: 40mm/s, 12mm/s initial layer speed, 20mm/s skirt speed
infill: 25%
Great print, no supports needed, love the little spiral details on the base.