knitgirl's Print of CatTree for Calicat
Community Print Impression 3D de CatTree for Calicat
Published 2020-02-15T16:33:53+00:00
1
1
Printed on: Anet A8
Material: PLA
Description
A place to store all of our calibration cats! I stuck some felt squares on the shelves with reposition-able glue dots, if my kid wants them on permanently we'll use actual glue.
Printed at .15mm, 200 degrees. Used a brim but wouldn't bother next time.
I found that a 1/8" wood dowel from the craft store was a snug fit but with a little effort could be worked in. Would recommend gluing despite the tight fit because the shelves will rotate otherwise with careless (kid) handing and dump the poor kitties right off.