Cyrex war gaming and tabletop tools's Print of Water pot for miniature painting - 6 shapes and sizes
Community Print Impression 3D de Water pot for miniature painting - 6 shapes and sizes
Published 2023-04-08T16:04:32+00:00
0
0
Printed on: Bambu Lab X1 Carbon
Material: PLA
Description
I have had an issue reported by a buyer, that the pot was not water tight!
I have done some testing and I have observed the same only when printing with silky filament at a "low" temperature. The prints I have done have used PLA.
The user that mentioned this to me fixed the issue by:
"I used a layer height of 0.16 with plus 5 bottom and top layers. This seemed to fix the leaking."
I have printed this on both my 0.4 mm Bambu lab X1 Carbon and my 0.6 mm Ender 3 V2 and both create pots that does not leak.
The below image show a 1.5 Hour print on my X 1 with standard 0.2 layer height and 10% infill.
Despite the bottom is "thin" it still holds water.
If others have issues, I can create a pot with more bottom layers.. Just let me know !