7.3 Powerstroke Hydra Tuner Dash Flush Mount
7.3 Powerstroke Hydra Tuner Dash Flush Mount
Published 2023-04-18T09:00:51+00:00
This is a quick 7.3 powerstroke Hydra Tuner flush mount I made in fusion 360 due to the shipping and expense of the actual flush mount offered on various diesel seller websites.
It has the tabs on the sides to clip and hold it into the square mounted hole once cut, I printed with PETG to widthstand vehicle summer heat but can likely be printed with most any filament. I have a picture of the hydra mounted in my powerstroke early bronco dash, plastic dash will also work (of course)
I printed it facing high / upright with some strategic locations for supports, I'm sure you can experiment and get a very nice print to work, it has the thumb tabs on the sides that press in to install and remove once the tuner has been popped out. Opening at the bottom provided for the cable.
UPDATE: PETG seemed to be quite brittle and hard to keep together when popping into the cutout hole. The black Hydra Tuner mount picture is printed from a rubber TPE filament which worked amazingly well and I think looks nice. I now recommend printing with TPE or TPU flexible filament.
Date published | 18/04/2023 |