Dial Indicator Ender3 Mount
Dial Indicator Ender3 Mount
Published 2020-03-22T06:50:13+00:00
To do the Bed level, I tried different options, but not with the expected results. So I decide to do this Support. It fits to any 20mm Aluminium Extruded profile face. Just add a couple of T nuts and M4 screws. The benefit is, that you can slide all over the extruded profile. Move the Bed over the Y axe as many times as needed with a gap of 3cm or 1 inch.
Printed at 40mm/s Print Speed, consider slower speed for small parts. Consider just a feew lines of wall, I use 0.8, so that gives you between inner and out wall a total of 1.6mm. Four layers for Top and Buttom. In order to have a clean print in the profile, I printed over one of the sides and include zig zag supports at 45°
-PLA
-Nozzle temp 210°
Date published | 22/03/2020 |
Tempo per farlo | 80 - 85 Minuti |
Quantità di filamento | 8 gm |
Dimensioni | 34mm x 41mm x 28mm |