FPV Drone 3" Pod
FPV Drone 3" Pod
Published 2017-11-28T18:55:45+00:00
This is a custom pod I designed for a 3" FPV racing drone. It has 30.5mm spacing to bolt right on top of whatever flight controller or ESC you use. It has built-in standoffs to give you the necessary clearance and was designed around using a Runcam Split. I may make a few more small changes, but nothing major. I will update the file here if I do make any further changes! Hope you can use this pod in your next build.
This print uses supports. I am sorry, but there was no way around it. If you do not feel comfertable using supports then I would suggest you not try this print. But hey, this may be a good learning experience for you to finally learn how to use supports. Its up to you!
Date published | 28/11/2017 |
Tecnologia | FDM |
Complessità | Difficult |