Octoprint Raspberry PI 3 and Camera articulated mount
Octoprint Raspberry PI 3 and Camera articulated mount
Published 2020-02-10T19:34:57+00:00
Hello Everyone !
I've always searched for a complete kit to mount a PI 3 and camera to my printer, so here's mine !
It's designed to be inserted on the standard extruded rails for printers like the CR10 or like me the Alfawise U20.
The PI case is made to fit a Raspberry PI 3B+ and a Pi Camera V2.1.
Important : You need to downscale the extensions to 40% for them to fit the other parts !
It's very easy to print, the only trick I can give you is to print it a little bit in the air with supports and a raft with Cura, like this the print will detach easily, especially if you have a buildtak print bed.
You may want to sand the ball ends, that's actually better. If you sand too much, like me, you can add a small square of paper in the recieving ends, it will be good.
You typically need :
- one rail mount,
- one case
- one long extension
If you want more length and/or flex, just add more extensions.
Feel free to modify this design !
-----
Base model credits :
- Camera case https://www.thingiverse.com/thing:3794890
- Pi case https://www.thingiverse.com/thing:604915
- Rail fit taken from https://www.thingiverse.com/thing:3973253
Date published | 10/02/2020 |