RSA SecurID angled holder
RSA SecurID angled holder
3D
Published 2020-04-21T19:18:17+00:00
A stand to hold an RSA SecurID token at an angle so it can be placed on a desk near the monitor, which comes in handy if like me you need to use it multiple times per day.
It holds the token tilted at a 45° angle. This is also the steepest overhang in the model, so it should be printable without using support material.
I printed the one in the images at 0.2mm layer height, and 50mm/s print speed.
I used 0% infill, 0 bottom layers and 6 perimeters to reduce printing time and material used.
6 perimeters is probably overkill, and the underside was a bit of a mess due to the interior 'valley' being started over thin air, however I didn't mind as this doesn't affect the useability of the stand.
The mininum print time of 36 minutes was how long mine took to print. The max is Cura's estimate based the above but with 25% infill, 3 perimeters and 6 bottom layers.
| Date published | 21/04/2020 |
| Tempo per farlo | 36 - 65 Minuti |
| Quantità di filamento | 9 grams |
| Dimensioni | 56mm x 31mm x 31mm |
| Supporto Gratuito | YES |
