I had a problem with the soap in the shower falling to the floor because the soap dish was installed wrong. So I build a quick little tray that would keep this from happening. My wife saw the tray and said she needed one for the bathroom sink. Well I could not put my simple one in a place people might see it (it was rather simple) so I wasted a day and built a more elaborate tray.
The one pictured was printed in low-res/low density mode to see if it would work. My printer had a couple of minor hiccups while printing, but it will function for now. The bonus is that now anyone with a similar sync can have a set of soap dishes.
The design is to hang over the outside edge of the sink to prevent the dish from visiting the drain.
This does require using supports to print since the overhang is lower than the dish. If you want you could reduce the back leg and print without supports.