Tensegrity Table | NO SUPPORTS | Lensor Radii
Tensegrity Table | NO SUPPORTS | Lensor Radii
3D
Published 2021-02-13T23:25:14+00:00
Structure without Support
How to assemble
Materials:
- 3 longer strings -- outer
- 1 shorter string -- center
- 1 base -- I recommend the ring, there's no need for the extra filament in the middle
- 1 top -- Orient this model 180° for printing, the file comes as assembled (upside-down)
1.) Start with choosing a suitable center string length, and getting that slotted in, making sure that the arm of the top does not drop below into the ring of the base. This will give you an idea of the length of string needed for the outer tensioners.
2.) Get the outer strings cut & tied now that you know the correct length (approximately), then insert all three into the base, pulling them tight into the chamfered slots (make sure not to put too much force on the arm if using a brittle material like PLA).
3.) One at a time, keeping the center string in place and under (some) tension, slot the other end of the outer strings into the table-top.
4.) After getting two in, you should be able to feel the 'balance' of the structure and get it in it's right place to get the final string slotted in.
5.) Don't sweat it. It took me a lot of trial and error to get it even standing, and getting it level was about impossible (All three outer strings have to be exactly the right length. I'm sure if you are good with knots/string, this would be a breeze).
You should now have a fully-assembled 3d-printed tensegrity table-top!
Confused? Leave a comment and I'll do my best to help out the best I can.
I've been debating making a video on the assembly, so if that would be helpful to anyone I'll make it.
Why did I make this?
I wasn't happy with any of the models I could find on thingiverse of a small tensegrity table that didn't require a lot of filament, but still had a solid top to set things on (and that didn't require supports!). Due to this, I designed my own, with blackjack and h--kers!
About the model:
The knots have space to sit flush underneath the model and with the table-top, and the base has a ring option as to not waste filament that isn't needed.
NO SUPPORTS/ RAFT NEEDED
Print one top and base, slot the strings in, and enjoy your new mini-table :)
4h total print time
| Date published | 13/02/2021 |
| Quantità di filamento | 25 grams |
| Dimensioni | 62.5mm x 62.5mm x String Length |
| Supporto Gratuito | YES |