Tesseract
Tesseract
3D
Published 2024-01-17T14:02:22+00:00
Fun 3d Tesseract. As is the cube is 3.8cm, A few days after I post this I will have some different sized prints to show and my settings in Orca slicer included. If you find this and have some free time to print it before i do please comment your settings to help me out, I hope to not lose too much time due to bad bridging as I scale up or down.
UPDATE: Made a 4inch cube and turned out quite well, as seen in the pictures above. Bridge settings were off but ill get that fixed with some sanding, wood filler, and paint:) results in the next update/comments when I finish!
50mm/s print speed
100% infill when cube side length is less than __mm (havent determined for myself)
220*C Print Temp
60*C Bed Temp
(PLA)
| Date published | 17/01/2024 |
| Tempo per farlo | 170 - Minuti |
| Dimensioni | 38mmx38mmx38mm |
| Supporto Gratuito | YES |
