This object was made in Tinkercad. https://www.tinkercad.com/things/2kuJ1RgtC5q

As you can see upper part and lower part are divided, but don' t worry it's not a problem with the design:  when printing i touched the object and it slipped away from the printingbed so i had to re-print the upper part and then i glued them together. 

I wanted to create a planter which could embrace the plant as if it was the seed of the plant itself. 

 You can either attach the pot to the wall (i attached it with some special tape, but you can do it with a nail ) or just put it down on a surface.