See it in action here: https://youtu.be/b5V4SJ_1uzQ

This is my take on the one motor walker robot by Burhan Saifullah which is itself a remake of Jerome Demers'

(http://www.instructables.com/id/How-to-make-a-one-motor-walker-without-bicore/)

Made to accept a 9g modified servo (http://www.instructables.com/id/How-to-modify-a-servo-motor-for-continuous-rotatio/)

Built in AAA battery pack with ON/OFF switch (https://www.myminifactory.com/object/favior-s-battery-case-16467)

Added the linkage arms that worked with my setup, should be fairly universal but just in case I added a set of blank linkage arms that can be cut and drilled to size.

This is a really fun project made to introduce kids to servos. Enjoy!

Print Settings

Rafts: No

Supports: No

Notes:

Printed the bushings and linkage arms at 10% infill The body printed at 5% with no problems. No support needed.

Post-Printing

The link arms will probably need sanding to make them smooth enough to pull/push the arms without snagging.

I drilled out all my holes prior to screwing, recommended.

I used 1" screws for front and top, a 1 3/4" screw to go through for the side axle.

Servo screws were locked down with small pieces of plastic with a 1/16th hole, or you can find very small screw/nuts for these.