18 - 200 mm CANON Lens Hood (EW-78D)
18 - 200 mm CANON Lens Hood (EW-78D)
3D
Published 2020-04-09T17:25:27+00:00 • Remixed from Canon EW-73B Lens Hood
Hey there people!
So I was looking to buy a lens hood for an old lens I have for an old camera. Seems like no shop had on stock so I decided to do some research and try and find one to print.
I had no luck in finding this model so I found an EW-73B that was very similar and remixed it.
I cut the bottom and twisted 90degrees the top in order to have the long "wings" above and below. Resized it to fit this little monster objective and here it is. I hope it helps and if you find any flaws, let me know.
Cheers
I printed the one in the photos using:
0.3
16% infill
45mm/s speed.
I recommend supports because of the rounded bottom. I tried it without supports and it didn't work out for me.
The one in the photos is more of a draft and I will print it on finer settings. I think 0.15 with a 20% infill would do great.
| 发表的日期 | 09/04/2020 |
| 让时间去下载 | 120 - 150 分钟 |
| 材料数量 | 25g |
| 尺寸大小 | 99.8mm x 98.8 x 41.6 |
