20V Craftsman Battery Adapter and Soldering Station
20V Craftsman Battery Adapter and Soldering Station
3D
Published 2022-01-11T09:37:40+00:00
This is a battery adpater for a 20V Crafstman Battery Lithium Ion pack and Soldering station. Desigend to power the MiniWare TS100, Pinecil and other compatible 12v to 24v DC soldering irons. The station provides a spool holder on the left for solder. The pin in the back is good storage for a small spool of wire or in my case a roll of soldering whick. The station stand tall enough to accomidate a 6AH battery. Unlike other 3D printed battery adapters for Crasftman batteries, this one actually locks onto the battery.
You will need the following items to complete this build
Aven 17530 Soldering stand. You will be using the iron holders, brass cup and brass whool from this stand to complete the solldering station.
2.5x5mm Female DC Jack
2.5x5mm Male to male cable
SPST Toggle Switch
2 strips of metal 24mmx17mm. No more that 1mm thick. Bent at a 90 degree angle 14mm from one end. I cut down a couple of PCI slot covers from an old PC case in one adapter and a sheet of galvanized steel purchased from Home Depot on another.
Some 18AWG wire
4x M2 16mm screws and nuts
Be mindful as you wire it up. The battery itself labels which terminal is posative and negative. Make sure you get the right terminal to the correct spot on the power jack. The bottom print has been labeled with the possative side.
0.2mm layer height 20% infill.
You will need suports
| 发表的日期 | 11/01/2022 |
| 让时间去下载 | 480 - 481 分钟 |
| 材料数量 | 115g |
| 尺寸大小 | 200x110x110 |