3d fillement brake system
3d fillement brake system
Published 2015-05-29T15:42:40+00:00
This brake system wil work with every printer but watch out with the fillement i use leapfrog it commes on black spools that fit exactly onto the holder
you can use it without the adapter and brakering
in the future i will come out with differet adapters and rings for different rolls ( or just ask )
you need to tap a m6 hole into the complete holder and a bolt with a rivet holds it in place ( tighten the bolt for more braking)
i print with this system for 1 year now without any error ( about 80 rolls so far)
use 50 % infill or higher for good strong results
good luck printing without any fillement errors
chef
Print at 0.2 mm layer height, with 10% infill. This uses 122 g of filament and takes 12 hours and 47 minutes.
发表的日期 | 29/05/2015 |
材料数量 | 122g |
尺寸大小 | 3 parts |
复杂程度 | 中级 |