Anet A8 Extruder Light
Anet A8 Extruder Light
3D
Published 2018-02-15T13:20:02+00:00
I created this LED light in order to properly see my extruder when printing. I couldn't use this one as to all the general types needing spaces I already used. Since connecting it to the back, front fan and side fan were all NOT possible** for me I created this. It can hold a single strip of 3 LED's (preferably white obviousy). Mounting is done by using the M4 screw on the underside of the extruder mount. It can be attached just like that. The extruder doesn't touch any part of the arc and doesn't warp since it's close to the fans.
NOTE: Using a semi-circular, full-circular or stock fan mount will probably not be possible altho I haven't tried it out. Let me know if it works out for you or not.
**I'm using the following things mounted to my extruder;
Spaceship fan duct
https://www.thingiverse.com/thing:2088006
Anet A8 Hinged Extruder Fan
https://www.thingiverse.com/thing:2290361
SN04 Auto Level Sensor Mount
https://www.thingiverse.com/thing:2019216
Printed at 0.12mm layer hight (0.2 will do).
60mm/s with 75% reduction for the perimeters.
Fans at 100% (gradually increasing over 4 layers 25% / layer)
| 发表的日期 | 15/02/2018 |
| 材料数量 | 1.55g |
| 尺寸大小 | e.g. 50x15x35 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
