Apple TV Siri Remote Case and Stand
Apple TV Siri Remote Case and Stand
3D
Published 2019-02-18T10:46:32+00:00
If you have an Apple TV there's a 50:50 chance that your remote is lost somewhere in the cushions of the couch. The remote is so thin and small that it lends itself to getting very lost. I spent over an hour trying to figure out just exactly how far into the inner workings of a reclining chair it had went before it was discovered. Never again!
So I came up with this. A case for the remote so that it'll be a bit bigger and not slide between the cushions of a chair. Functions as a stand so it can sit nicely on the coffee table and not be lost under magazines and clutter. Plus makes it a bit more natural to hold while it's in use. Has an access hole for the Lightning charging port.
Holds onto the remote with cohesion, if your printer's tolerances prints this a bit loose. A strip or two of painters tape on the back of the remote will help thicken it up enough for a good fit.
| 发表的日期 | 18/02/2019 |
| 打印工艺 | FDM |
| 支持自定义 | YES |
