AR60 8-degree Knuckle with Mount holes
AR60 8-degree Knuckle with Mount holes
Published 2021-10-18T16:23:48+00:00
This is an 8-degree knuckle that will fit a standard AR60 knuckle mount. It's designed as a 3-piece part to build a strong and easy to print knuckle.
Intended to be used in RC Comp Crawlers like Sporty/Shafty and/or MOA type of RC crawlers.
The benefits over the standard stock knuckle are:
- Includes weight mounting holes
- Includes the second set of holes to have screw stoppers that will allow you to tune steering limits to protect the rig against crashes or object strength against the wheel on full lock steering.
- Built-in steering links mounts options that are set at a higher position to enable more clearance with the AR60 axle pumpkin.
Print flat, preferrable with Nylon filament. PETG will also be ok if you are gentle with your rig.
Depending on your printing setup, print support might be required.
Since this is a mechanical piece, it's required the print to be precise in size (e.g. to fit bearing properly). Make sure to measure after print to confirm your printer accuracy. If it's not accurate, expect to trim the parts a bit or tune your print setting and/or printer.
发表的日期 | 18/10/2021 |