Baby Bottle Training Grips - Medela
Baby Bottle Training Grips - Medela
3D
Published 2015-04-02T14:35:49+00:00
This is a single-piece hand grip that goes on a 5oz Medela baby bottle, to help your little one learn to hold up the bottle herself. It goes on underneath the bottle lid, and three small crush-tabs on top automatically adjust to the bottle and lid, for a snug fit regardless of printer calibration. The design has been graciously (and sometimes not-so-graciously) beta tested by my 6-month-old daughter. Obviously, let your baby use these grips only with supervision; they are for learning, and not intended to be a chew toy.
Print at 0.3mm layer height, with at least a 25% infill and 1.5mm thick shell. This will take between 2 and 2.5 hours, and use 23g to 38g of filament. There are some small baked-in supports at the base of each handle (optimized for 0.5mm extrusion width); remove them with flush cutters or a hobby knife and make sure there are no sharp edges left.
| 发表的日期 | 02/04/2015 |
| 让时间去下载 | 120 - 150 分钟 |
| 材料数量 | 30 |
| 尺寸大小 | 88 x 81 x 39 mm |
| 复杂程度 | 容易 |
