Bang! The Dice Game Printed Pieces
Bang! The Dice Game Printed Pieces
3D
Published 2018-11-28T16:51:10+00:00
Hi everyone,
My son wanted a bit more depth and fun to this already fun game, so I did these for him and now all of his friends want them.
It was a pretty fun print to do. It can all be printed in one day with multiple printers or 2 days with one printer.
The bullet is thanks to JaredNew. I remixed the 3 bullets from his single bullet design.
The arrows are thanks to muzz64. I used the single arrow for this.
The storage cases are thanks to webdad. I used one of his storage cases and sized it to fit the bullets.
I printed everything without supports or brims.
I did use a skirt to purge the filament.
The larger 3 bullet box took about 3.25 hours and the lid took about 1 hour.
The smaller single bullet box took about 2.25 hours and the lid took about .75 minutes.
I printed the bullets 12 at a time.
The 12 single bullets took about 1.25 hours and the 12 tripple bullets took about 3 hours.
I used Rustolium Metalic gold to paint the bullets.
I printed 9 arrows and it took about 1.25 hours.
The print time will all depend on your slicer settings. You can also print all of them at once depending on your printer set up and bed leveling.
In total I used approximatley about 175g of filament
Everything should fit perfect after it's all put together and stored in the original box.
I used my vinyl cutter to cut the black decals on top of the cases.
Cura 3.6 settings:
Layer Hight - .2
Nozzle - 213, Inland Gold and Silver Filament
Bed - 60
Walls - 3
Top and Bottom layer - 3
Infill - 10%, more if you want the bullets a bit heavier.
Skirt - yes
| 发表的日期 | 28/11/2018 |
| 支持自定义 | YES |