Basic Tweezers
Basic Tweezers
Published 2020-08-16T18:35:14+00:00
I was gonna make another gag commercial to go along with this like I did with other designs, but then I remembered... these are friggin tweezers. Holy dang diddly dumpster dooky, a simple design for tweezers; cuz here at FFFTechnology, we've lost these things so damn much. Like sweet buttery biscuits, we're sick of going all the way to Walmart, just to buy ANOTHER pair.
Close them lightly so the tips come together, close them slightly harder for the tweezers to get a bit of a better hold on something.
So here ya go... Tweezers.
Sanding Instructions:
Since I use a FDM/FFF printer, when printing small objects, fine tips often become slightly blobby. If this occurs for you, simply run the inside of the tips down with a fine grit sandpaper, only a pass or two should be needed. Make sure after sanding you close the tips in front of a light source; visually inspecting to see if any light shows through. If not, they should grip fine hairs and the like quite well. If not, make a pass or two more of sandpaper. Repeat as necessary.
Standard Print Settings:
Extruder: 208C
Bed: 56C
First Layer Print Height: .22mm
Wall Thickness: .40
Wall Perimeters: 4
发表的日期 | 16/08/2020 |
支持自定义 | YES |