bullets for confetti six shooter
bullets for confetti six shooter
3D
Published 2015-04-23T13:33:02+00:00
I had a confetti six shooter and it was boring so i made these, they work really well!
There are two types, a flat bullet and a pointy one, i made the flat one first to see how it would shoot.
They are slightly smaller than the barrel so they slide out if you dont have the cardboard disk to hold it in place
i printed mine at 0.4mm layer height and it worked fine
WARNING
-use under adult supervision
-do not point at people's faces
-do not fire close to the ears
-keep out of reach of children
Iam not responsible for whatever you do with them, if you shoot someone in the eye, it's your fault.
Print at 0.2 mm layer height, with 10% infill. This uses 1 g of filament and takes 14 minutes.
| 发表的日期 | 23/04/2015 |
| 让时间去下载 | 8 - 18 分钟 |
| 材料数量 | 1g |
| 尺寸大小 | 2 parts |