Car in garage handle
Car in garage handle
Published 2020-09-14T08:37:26+00:00
I noticed that there was a lack of a nice functional Car-in garage handle on the market so I decided to design my own. This has been tried and tested by a friend of mine who thought it was an excellent spare and works perfectly.
I would suggest that you print it in PETG in case there is intense sunlight on the garage. it will probably withstand the hight heat and also it will be a bit more resistant to UV-light.
Keep in mind though that PETG is a bit more flexible so that you might want to keep the perimeter count high.
The model requires a little support in the fastener-points. It is possible to print the other sections without supports but for a perfect result i would suggest to print support like the picture of prusaslicer suggests.
发表的日期 | 14/09/2020 |
材料数量 | 100 grams |
尺寸大小 | 138 mm x 49 mm x 86 mm |