Charging-Dock for UE BOOM
Charging-Dock for UE BOOM
Published 2018-03-23T12:01:59+00:00
BEFORE YOU PRINT: Check out my new version of the dock.. it's better.
I desinged this dock in order to have a home for my UE BOOM 2 speaker in my room. It fits the original charging cable which came with your speaker. I desinged it to be clean on the outside, but to fit you speakers form perfektly from inside. Simply drop you speaker in for a charge!
This dock shoul fit for UE-Boom first and second Gen. If you with one for the big one let me know!
1. Print the two parts "top" and "bot"
2. Clean up the parts till they fit seamlessly
3. feed your cable through the hole of th top part and connect it to the speaker.
4. Place the speaker in the dock. (You will have to remove the screw and the rubberpart from the box)
5. Add the bottom part and make shure to give the cable a tight fit.
6. Scew on the bottom peace with four M4*12 zylindrik bolts.
7. The base of the speaker may warp a bit. you might want to add some rubber feet or glue it to a surface with some hotglue or doublesided tape.
发表的日期 | 23/03/2018 |
尺寸大小 | 8cm x 8cm x 6cm |
打印工艺 | FDM |
复杂程度 | 容易 |
支持自定义 | YES |