Coin Holder USA
Coin Holder USA
3D
Published 2019-05-24T15:08:04+00:00
Designed to be robust and last inside a car.
PLA will temper over time in a hot car, but will melt in a very hot car (especially in direct sunlight), but I've never had any problems with mine (printed in PLA) after years of use.
PETG or ABS is recommended if you are placing this in direct sunlight in the car.
Can be printed on most printers, doesn't require any high resolution, or small layer heights. Though with larger nozzles and layer heights, the text on the bottom will not be as clean.
2-3 wall layers (depending on nozzle size) for strength and a decent infill to last (around 20% is recommended, but not critical to a successful print).
105.15 x 65 x 23 (mm)
4.14 x 2.55 x 0.9 (in)
Thanks and enjoy!
| 发表的日期 | 24/05/2019 |
| 材料数量 | 47.2g @3 shells 20% |
| 尺寸大小 | 105.15 x 65 x 23 (mm), 4.14 x 2.55 x 0.9 (in) |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |
Layer Height:0.2mm