Companion Cube Keychain
Companion Cube Keychain
3D
Published 2016-06-08T17:10:01+00:00
I took the companion cube with hearts, and made a keychain out of it, as requested through our Etsy.
Check out our Etsy for all of our 3D printed awesomeness!
https://www.etsy.com/shop/CarryTheWhat
The size of the cube is 3cm per side.
Instructions
Print with a bit of support, paint it if you'd like, and attach a key ring. I suggest a thin keychain, it seems like the thicker ones will leave it prone to breaking.
The OpenSCAD loads in the STL, and then you position the keychain loop. Might be useful in making other keychains.
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Companion Cube Keychain by CarryTheWhat is licensed under the Creative Commons - Attribution - Share Alike license.
| 发表的日期 | 08/06/2016 |
| 打印工艺 | FDM |
