COVID-19 Face Shield Visor
COVID-19 Face Shield Visor
3D
Published 2020-04-08T02:05:13+00:00
After many many times of changing and testing, I have finally come up with this visor, which I think is quite practical.
It is a two-piece design to hold a standard 3-hole transparency film.
I made use of the elasticity of the filament so the outer piece will clamp into the inner piece so that it can hold the transparency film in position.
I tried my best to make the curvature of the front piece similar to sunglasses, so that it would feel more natural.
The plugs on both pieces allow them to lock into each other securely.
I also added an inclined surface on the back side of the inner piece, so when it is pressed on your forehead you will feel more comfortable.
Based on the individual, an elastic may be required at the back ends of the visor to fully secure it.
It can be reused, just disassemble after each use and clean it with soap and water.
Revision R1
COVID-19-outer-r1 legs shortened
COVID-19-visor-inner-r1 distance to transparency increased 10mm, middle hole enlarged 0.4mm for easier assembly.
Revision R2
COVID-19-visor-inner-r2 face in contact with forehead modified and enlarged.
You can use 0.4 nozzle or higher.
For 0.4 nozzle:
set layer to be 0.25mm
wall line to be 3
nozzle temperature 5~10 degree higher is better
No infill required
Support required
Printing time for Inner piece is 1 hr. 15 min, Outer piece is 41 min.
| 发表的日期 | 08/04/2020 |