Doctor Who Sonic Screwdriver
Doctor Who Sonic Screwdriver
3D
Published 2018-02-05T18:44:39+00:00
Hi all,
I have created a replica of a Sonic Screwdriver, and oh my, it (almost) works. See Sonic Screwdriver demo video below. The original was used by the Tenth Doctor Who, David Tennant, who played in the series from 2005 until 2010.
Elaborate instructions on what's needed, how to print and how to assemble is included in the pdf manual (see tab "documents attached"). As I didn't have silver coloured filament and transparant blue, I had to improvise somewhat as is being described in the instruction. Naturally you can avoid the painting and fiddling by just ordering the right coloured PLA. The flashing LEDs are created using a bicycle light. I have added a picture of the version I used. Depending on your version you might need the 2 battery pack or the 4 battery pack.
The box has been printed using ColorFabb Woodfill. Two versions are uploaded. I have used the 2 mm version in combination with a paperclip for the hinges. You can also use the three mm version in combination with a piece of filament to create the hinge.
Have fun!
Marco
See elaborate instruction in the PDF.
BOM:
filament: transparant (e.g. colorfabb clear_XT), blue, white and black, woodfill
Super glue
Bicycle Led light (blinking led)
Switch (push button)
Electical wire
Heat shrink tube
Four LR44 batteries
Paper clip
Used print settings (depends on filament type used and printer):
Nozzle temp: 190 dC (for the colorfabb clear_XT I used 250 dC).
Nozzle size: 0.4, except for Woodfill where I used 0.8
Speed: 100 m/s
Bed temperature: 60 dC
I used a brim, but it also prints without
Tools:
3D printer
Solder station
Silver paint (in case of using white filament).
Sanding paper
| 发表的日期 | 05/02/2018 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
| 支持自定义 | YES |