Double Headed Fantasy Axe
Double Headed Fantasy Axe
3D
Published 2015-01-01T20:00:16+00:00
A fantasy double bladed battle axe which fits comfortably in both hands or as a single handed weapon. Used as a decorative piece once painted like shown or if glued for strength it can be used as a prop.
Start by printing the axe head on which all the section will be connected to. Afterwards print off two axe heads (they are the same file) and snap fit them into the axe head. The next bit that needs to be made is the hilt which fits the axe head and hilt together, then print of the top section of the staff with the coupling pieces as well. The final bit to print is the lower section of the staff which is fitted together to the top section of staff through one of the coupling joints and then the whole staff is connected to the hilt again with the coupling joint. It is printed with about a 40% infill but can be less.
| 发表的日期 | 01/01/2015 |
| 让时间去下载 | 2100 - 2699 分钟 |
| 尺寸大小 | 330mm X 20mm X 670mm |
| 打印工艺 | FDM |
| 复杂程度 | 中级 |