Drive Wheel For Neato Botvac D3 D4 D5 D6 & D7
$5.00 Drive Wheel For Neato Botvac D3 D4 D5 D6 & D7
3D
Published 2022-05-31T09:38:49+00:00
A fully-functional drive wheel for the Neato Botvac D series (D3, D4, D5, D6, D7). Print two for a set (it works in either direction).
Combines the tire & wheel into a single piece. Useful for when your original tires get worn down and need to be replaced!
You'll likely print this in a harder plastic than the more rubbery tires the original has; try roughing up the surface with sandpaper or letting it run a few times to break in the new wheels.
Size: 7.6 cm (diameter) x 3.3 cm (length, including axle)
You'll probably encounter a lot of resistance when screwing the bolt back into the wheel during assembly; this is because the screw is tapping the axle as it goes in (creating the threads). Consider loctite or another adhesive to better secure the screw and ensure it doesn't loosen over time from wear.
Check out the video to see it in action on my own D5:
https://www.youtube.com/watch?v=RJ2wlq7VmvU
Doesn't need any supports; I recommend printing in PETG if you have it so it's got at least a bit of softness to it. If not, go with ABS (what I printed mine in). Nylon will work too (and will have the longest life span). Print in 100% infill!
Doesn't need any supports; I recommend printing in PETG if you have it so it's got at least a bit of softness to it. If not, go with ABS (what I printed mine in). Nylon will work too (and will have the longest life span). Print in 100% infill!
| 发表的日期 | 31/05/2022 |
| Price | $5.00 |
| 尺寸大小 | 7.6 cm x 3.3 cm |
| 支持自定义 | YES |