This model is designed to house the Anet V1.0 mainboard and two fairly standard Mosfet boards and is intended to be fitted to the side of an enclosure. The Mosfet boards should be positioned as pictured.
Top hole for access to Anet V1.0 Board USB Port and Micro SD slot.
Bottom holes for power cables to enter the case. Positioned to line up with the power input on the main board and power inputs on the Mosfets.
Holes in the interior. They are positioned to allow cables to be fed through from the inside of your printer enclosure to the relevant points on the main board.
Mounting posts for the above mentioned boards.
Positions to screw the lid onto the case.
4 M3 holes to mount the box to the side of your enclosure.
The Lid features a position for mounting an 80mm fan above the main board. and slots below to improve airflow.
You will also need:
M3 screws - around 10mm long for the case lid (4) and around 8mm long for mounting the boards (12).
Screws suitable for the fan you wish to mount.