Fancy Marble Spinner
Fancy Marble Spinner
3D
Published 2017-07-17T11:33:51+00:00
This object was made in Tinkercad. https://www.tinkercad.com/things/bGdYfXXbSSj Spinner, using marbles as a bearing. The center hub can be resized or sanded to improve overal fit. On mine, I sanded the hub (the points on the inside) to make it shorter so that the curves would help push the marbles out to the outer ring. The ring is set for 5 marbles at 16.4mm which is a bit sloppy but guarantees a good print even if the extruder leaves strings or bubbles.
No rafts or supports needed. Model is in 4 parts. The two big parts are about 140mm each. Took about 8 hours for all parts on my Solidoodle. Held together using 6 x #10 screws x 0.5 inch and 1 #10 sccrew x .75 inch. All screws have tapers (45 degree counter sinks) and nuts.
| 发表的日期 | 17/07/2017 |
| 让时间去下载 | 8 - 分钟 |
| 尺寸大小 | 140 |
| 打印工艺 | FDM |
| 支持自定义 | YES |
