Fang_with_Dial_Arm_V2
Fang_with_Dial_Arm_V2
3D
Published 2018-03-06T13:01:50+00:00
This is a remix and combination of two separate objects from Thingiverse for the CR-10 and CR-10s printers. The first one is Dualfang by spider65 https://www.thingiverse.com/thing:2722733. I just fixed a mesh hole in this one. The second is Short Dial Holder by lucassaldanhawerneck https://www.thingiverse.com/thing:2696551. A major mesh rework on this part including combining both into a single mesh with shared mount points.
Fang_with_Dial_Arm_V2 has an error when you click on Click & Print preview link. It shows the object with support everywhere. This will make this object unusable. Support is generated inside the Fang duct. This will block the duct and is nearly impossible to remove. The support setting should be touching build plate only. Print with mount plate side down as shown on Click & Print preview link.
| 发表的日期 | 06/03/2018 |
| 让时间去下载 | 360 - 420 分钟 |
| 材料数量 | 48 GRAMS |
| 尺寸大小 | 102.7 X 108.6 X 66.7 |
| 打印工艺 | FDM |
| 复杂程度 | 容易 |
