FCX24 Micro Komodo Conversion
FCX24 Micro Komodo Conversion
3D
Published 2022-08-05T08:31:32+00:00
Adapter to fit a SCX24 transmission and Furitek Micro Komodo brushless motor to a FCX24. This is designed to work with the Furitek mount for the Micro Komodo. Removal of the stock 2-speed transmission and shifting servo is required. No cutting or drilling of the chassis is needed. The battery divider allows for use of the stock battery, the Orlandoo Hunter 2s 260mah, or 3s 180mah without fear of the battery hitting the spinning outrunner. There are also notches in the battery divider to allow for routing of cables.
Drill out the holes for the SCX24 transmission with a 1.2mm bit. The holes for the FCX24 hardware should be 1.7-1.8mm to work properly. Drill out the spacer with a 1.5mm bit. It sits between the topside SCX24 transmission tab and the adapter. A bit fiddly, but allows for much easier printing.
- PETG recommended
- 0.4mm layer height
- Print the adapter upside down
- Print the battery divider standing up
- Print the spacer standing up
| 发表的日期 | 05/08/2022 |