flite test master-series corsair detachable winglock
$2.00 flite test master-series corsair detachable winglock
Published 2023-03-01T15:52:52+00:00
This is my take on an idea another pilot did with his build. I have employed the same concept because it's a good one. My part however is form fitting basing it's geometry off of the wing spars and fuse. which means as long as your close when building your wing it should fit snug. I trim some around the front wing inner edges because my latch fits down in between them and goes under the cowl. The brilliance of this design is that the wing is quick detachable. It can be transported and then assembled by sliding the rear of the wing under a notch and then the latch can be slid under the cowl and it snaps in place. Using cantilever action against the wing it can be printed super light if done in lwpla. It only requires a small force of the magnet to hold the wing securely in place. It has a fat finger hole for you bannana hands. I have included two versions, one in segments and one complete. they both have holes the size of standard filament so you can insert carbonfiber or whatever filament to strengthen the latch. solid is better but the increase in tensile strength with the segmented piece is more than sufficient. Use ca glue and activator. Printing complete with no supports failed for me at the end with lwpla but I had no supports and I didn't pursue farther. With some encouragement it will print fine but for the rest of us the segmented one is what I'm flying. I have holes availabel for the stock magnets and also .2x.375 in (5x10mm) magnets that I keep on hand.
This print plus the camera mount for the Focke Wulf in third person would be dope. Yet to come are replacement parts and a platform between the wing spars for the fc. If I had a little interaction with you all on here I would design parts for matek or zohd or whatever the demand is. I will first make it for the aura 5 since that is the FT go-to board. Many of you will already have it on hand and if you don't you should because it gives you that little extra freedom while still having 6axis gyro covering your aft.
发表的日期 | 01/03/2023 |
Price | $2.00 |