Insulation Load Spreading Retaining Washer
1,361
views
56
downloads
0 comments
Loading comments...
Insulation Load Spreading Retaining Washer
3D
Published 2020-11-24T11:25:34+00:00
2
0
Add to Collection
Description
Spread the load / increase fixing area when mounting insulation/plasterboard with screws. 60mm Diameter.
TIP: Print without supports by moving 1mm below the build plate (z-axis -1mm).
There is an additional 1mm deep notch on that side that faces to insulation, this adds even more support like most retaining clips. However, it becomes more difficult to print, so far I've never needed it. Printing at 0.2 or 0.3mm doesn't seem to affect practical usage.
允许
Printing Details
### Supports
no
### Resolution
0.3
### Infill
20
### Misc Notes
Print without supports by moving 1mm below the build plate (z-axis -1mm).
Technical Information
发表的日期 | 24/11/2020 |
让时间去下载 | 25 - 分钟 |
More Information
Object Parts